|
Remove your old pedals with an open-end spanner of the correct gauge - probably 15mm.
It should be a tight fit with no slippage and thin enough to fit between the pedal and the crank.
IMPORTANT: The left-hand pedal HAS A LEFT HAND THREAD so turn clockwise to remove it!
The right-hand had pedal has a normal right-hand thread, so turn it anti-clockwise to remove it.
Fitting your Ledals: Note the letter engraved into the pedal bolt.
You should see an 'L' or an 'R' indicating which pedal is left and right.
You need to install the left-hand pedal on the left hand side of the bike and the right-hand one on the right.
Your Ledals should be tightened well,
but remember that you'll want to get them off at some point so don't overtighten!
That's about it for fitting, make a quick test to see all is well.
Enjoy your Ledals and please remember: Ledals complement conventional cycle lighting systems.
They are not intended as a sole lighting solution - they add to your visibility AND ARE ALWAYS ON THE BIKE!
|
![[ AWARD-WINNING BICYCLE SAFETY ]](pix/awardwinning.gif)
